- WEMScontroller4 (see below).
- Run FP AHU Discover Wizard.
- Configure FP AHU Control Points.
The following steps define how to set up an FP AHU for the first time. If you would like to amend the settings of an FP AHU that has already been configured, see the FP AHU Configuration guide.
To set up an FP AHU for the first time, begin by discovering and configuring a WEMScontroller4, using the Auto Discover Wizard. One WEMScontroller4 is needed per FP AHU.
In addition to the above steps, the FP AHU setup requires that the system is able to measure the Outside Air Temp and the internal room space temperature. Existing temperature sensors can be used to provide these measurements.
The following process must be performed BEFORE attempting to use the FP AHU Discover Wizard.
WEMScontroller4
Begin by running the Auto Discover Wizard ( | ) and detecting the WEMScontroller4. For more detailed information on how to run this wizard, see the Auto Discover section.
- Click to begin the wizard.
- Press the button on the WEMScontroller4 in order to discover the device.
- The device will be discovered. Click to continue.
- The device will be configured by the wizard. Click to continue.
- Give the device a meaningful name, and then click to continue.
- Specify a location for the device, and then click to continue.
- Click to automatically assign the necessary channels to the WEMScontroller4. For information on what this button does, see .
The button will grey out to signify that the necessary channels have been configured on the WEMScontroller4.
- Click to complete the wizard and return to the Floorplan.
Next Step
The next step is to run the FP AHU Discover Wizard.